With this feature, it is unlikely that your vehicle will tilt. Hydraulically controlled legs are also available to help in lifting your fully loaded container and keep the trailer in position. However, the case is different for these cranes that get powered via a PTO from the trailer. In a typical set up, the cranes get powered via a fuel engine. The cranes are usually located on top of the side lifter chassis and are normally able to move along the trailer chassis that gets shifted via hydraulic actuators to handle different container lengths. With this setup, container lifting can be achieved on and off the chassis. Commonly known as crane modules are cranes powered through a hydraulic system that help in lifting a container off the ground or from another vehicle onto a trailer. This is made possible through the following features:
Using a Container Side Lifter TrailerĪ container can also be loaded onto a trailer through a side lifter. When the trailer’s lower frame is fit with respect to the trailer body, the pivotal movement triggered on the upper frame about the hinging point axis will produce a loading or an offloading position as needed.Ĭontact us 2. Remember that this is only applicable when doing a dumping procedure. This can be attained by moving about the point where it is hinged on the lower frame rather than the upper frame during such an operation. It is also important to note that the lower frame is pivotally attached with respect to the body of the trailer to facilitate a dumping operation. This makes it possible to attain the movement and lift for the container without the need for external force or power to change the cable distance. The pivotal drive through the upper frame contributes to a change in the separation distance between the roller and the cable securement point with respect to the lower frame and the change in the distance between the cable securement point and the roller with respect to the container structure. Most important to note is that the extension arms can extend outwardly and make possible the offloading process as well. There is also an extension arm that is longitudinally contractible that helps in managing the weight of the container. In this arrangement, the roller can move over the upper frame with respect to the lower one. The roller works by rotating around the point of mounting at the upper frame. The upper frame comes with a roller installed at some distance from the pivot device and perfectly attaches it to the frame below.
Though an expensive option, you will not have to worry about the loading requirements due to the convenience that it gives you. The upper platform is hydraulically controlled to enhance lifting operations. Its designed for easy loading and offloading of containers and would not need the use of a crane. Typically, the trailer has lower and upper arms that are attached via a pivot device. The apparatus installed on it simplifies the procedure for loading containers on it. The container tilt trailer structure is designed in a way that facilitates self-loading of containers on its trailer bed. Using Container Tilt Trailer, Which Can Load By Self Therefore, operations should be made following standard procedures that enhance safety at all times during loading, transportation and offloading at site and/or destination.Įssentially, there are 3 different ways of loading your container onto a trailer as will be discussed here, three Ways to Load a Container on Trailer when you don‘t have a container crane in your workshop:Ĭontact us 1. Loading your container perfectly onto its trailer is one of the things you must understand to benefit from your equipment and vehicles.
0 kommentar(er)
